Q-Logic OFED Network Router User Manual


 
Draft
IB0056101-00 G.02 Preliminary 3-1
3 Step-by-Step
Installation Checklist
This section provides an overview of the hardware and software installation
procedures. Detailed steps are found in Section 4Hardware Installation” and
Section 5Software Installation”.
Hardware Installation
The following steps summarize the basic hardware installation procedure:
1. Check that the adapter hardware is appropriate for your platform. See
Table 4-1.
2. Check to see that you have the appropriate cables and switches, as
described in “Cabling and Switches” on page 4-3.
3. Check to see that you are running a supported Linux distribution/kernel. See
Table 5-1.
4. Verify that the BIOS for your system is configured for use with the QLogic
adapter. See “Configuring the BIOS” on page 4-4.
5. Following the safety instructions in “Safety with Electricity” on page 4-5.
Unpack the adapter (“Unpacking Information” on page 4-5) and verify the
package contents.
6. Install the adapter by following the instructions in “Hardware Installation” on
page 4-9.
7. Cable the adapter to the switch, as described in “Cabling the Adapter to the
InfiniBand Switch” on page 4-17. Check that all InfiniBand switches are
configured.
8. Follow the steps in “Completing the Installation” on page 4-18 to finish the
installation.