Filter
Top Products
Draft
Hardware Installation
Hardware Installation
IB0056101-00 G.02 Preliminary 4-15
A
13. Insert the HT riser assembly into the motherboard’s HTX slot, ensuring good
contact. The QLogic adapter should now be parallel to the motherboard and
about one inch above it, as shown in Figure 4-9.
Figure 4-9. Assembled QHT7140 with Riser
14. Secure the face plate to the chassis. The QLogic adapter has a screw hole
on the side of the face plate that can be attached to the chassis with a
retention screw. The securing method may vary depending on the chassis
manufacturer. Refer to the system documentation for information about
mounting details such as mounting holes, screws to secure the card, or
other brackets.
The QLogic QHT7140 with HTX riser card is now installed. Next, install the cables
as described in “Cabling the Adapter to the InfiniBand Switch” on page 4-17. Then
test your installation by powering up and verifying link status (see “Completing the
Installation” on page 4-18).
Hardware Installation for QLE7240, QLE7280, and QLE7140
Without a PCI Express Riser
Installing the QLogic QLE7240, QLE7280, or QLE7140 without a PCI Express
riser card requires a 3U or larger chassis.
Installation is similar to the QHT7140 HTX adapter, except that the card slot
connectors on these adapters fit into the PCIe slot rather than the HTX slot.
Follow the instructions in “Hardware Installation for the QHT7140 Without an HTX
Riser” on page 4-16, substituting the PCIe slot for the HTX slot.