Q-Logic SANBOX2-8C Switch User Manual


 
5 Diagnostics/Troubleshooting
Recovering a Switch
5-12 59042-02 A
5. The maintenance menu displays several recovery options. To select a
switch recovery option, press the corresponding number (displayed in
option: field) on the keyboard and press the Enter key.
0) Exit
1) Image Unpack
2) Reset Network Config
3) Reset Password File
4) Copy Log Files
5) Remove Switch Config
6) Remake Filesystem
7) Reset Switch
Option:
These options and their use are described in the following sections.
5.3.1
Maintenance Exit
This option closes the current login session. To log in again, enter the
maintenance mode account name and password (prom, prom).
5.3.2
Maintenance Image Unpack
This option unpacks and installs new firmware when the current firmware has
become corrupt. Before using this option, you must load the new firmware image
file onto the switch. The steps to install new firmware using this option are as
follows:
1. Place the switch in maintenance mode. Refer to the procedure for
maintenance mode in Recovering a Switch on page 5-11.
2. Use FTP to load a new firmware image file onto the switch. Refer to Using
FTP and the CLI to Install Firmware on page 4-17. Do not unpack the
firmware image file with the Image command.
3. Select option 1 from the maintenance menu. When prompted for a file name
prompt, enter the firmware image file name.
Image filename: filename
Unpacking filename, please wait...
Unpackage successful.
4. Select option 7 to reset the switch and exit maintenance mode.
5.3.3
Maintenance Reset Network Config
This option resets the network properties to the factory default values and saves
them on the switch. Refer to Table B-6 for the default network configuration
values.