Filter
Top Products
M16C/26 Group
Rev.0.90 2003.12.28 page 25 of 28
Under development
Preliminary specification
Specifications in this manual are tentative and subject to change.
2. Differences Made Depending on Manufactured Time
2.1 RESET Input
Ensure that pin RESET must hold valid-low state during powering-up.
When using a reset IC, use a CMOS type IC. When using an open-drain type reset IC, insert a capacitor
between the reset input and Vss and a resistor between the input and Vcc respectively. The R-C time
constant of the capacitor and resistor must provide a low state at least 10 times longer than the Vcc rise
time.
2. Difference Made Depending on Manufactured Time