Renesas M16C/30P Network Card User Manual


 
M3062PT2-EPB User’s Manual 3. Usage (How to Use the Emulator Debugger)
REJ10J0868-0200 Rev.2.00 January 16, 2006
2. Specifying the communication interface
Specifying the communication interface
(LPT communication)
- For selecting the LPT communication, click the radio
button “LPT” of the MCU tab.
- For the Type area, specify the LPT interface
communication mode to be used. When you use the
emulator debugger for the first time, select
“AUTO”.
- Specify the I/O address of the parallel port at the I/O
address area.
- For BIOS setup, the following addresses are
available.
- 378h
- 278h
Specifying the communication interface
(LAN communication)
- For selecting the LAN communication, click the radio
button “LAN” of the MCU tab.
- Specify the IP address of the emulator at the IP
address area.
- Specify the IP address by one byte of decimal number
separating each four bytes with a period.
- Specify the port number at the Port area.
[Supplementary explanation]
When you are using the LAN communication for the for
the first time, connect the emulator through other than
LAN communication interface and set the IP address, or
use the SETIP utility included with your product to set
the IP address.
For details about the SETIP utility, refer to the on-line
manual of your emulator debugger.
Specifying the communication interface
(USB communication)
- For selecting the USB communication, click the radio
button “USB” of the MCU tab
- The emulators connected by USB cable are shown at
Serial No. area.
- Select the serial No. of the emulator you are going to
connect.
[Supplementary explanation]
When you are using USB communication for the first
time, you must install the USB driver first.
The USB devices are detected when you turn on the
power for the emulator, and a wizard for installing the
corresponding device driver will automatically be
started. Follow the instructions of the wizard to complete
installation.
Page 50 of 102