Filter
Top Products
( 28 / 76 )
Chapter 3. Setting Up
To use this emulation pod with your target system, it is necessary to set as follows. Set the following
after removing the upper cover.
• Change the oscillation frequency in the emulation pod.
• Set the switches depending on the target system.
• Install pullup resistors to ports P00 to P57.
• Install the A-D conversion bypass capacitor.
• Change the input frequency for FSC oscillation.
• Change the constant of the circuit for data slicer I/O signal.
3.1 Removing the Upper Cover
The procedure of removing the upper cover is shown below.
(1) Remove the four screws of both sides of this product and lift off the upper cover. (see Figure 3.1)
(2) Set the switches.
(3) Replace the upper cover and secure the four screws.
Figure 3.1 Removing the upper cover
CAUTION
When Removing the Upper Cover:
• Always shut OFF power when removing the upper cover or setting the switches.
•Do not touch the connector pins of the emulator main unit and the target MCU
connector pins. Static electricity may damage the internal circuits.