Filter
Top Products
4 Using the FoUSB
5) “PROGRAM” button
This button performs programming to the Target MCU.
(1) Click the “PROGRAM” button, and the screen shown in Figure 4-20 will appear.
Figure 4-20 Program Flash screen
(2) In the Choose an Options section, select either “Erase -> Program -> Verify” or
“Program Only”.
(a) Erase -> Program -> Verify (without lock bit function)
When you select this option, processing is performed in order of Erase, Program and
Verify. A progress bar is displayed, indicating the progress of processing in Erase,
Program and Verify.
(b) Program Only (without lock bit function)
When you select this option, processing is performed for only programming. A progress
bar is displayed, indicating the progress of processing in programming.
Note: The following warning will be displayed if clicking the “Program Only” before
erasing the Target MCU. Clik the <Yes> button, only when Target MCU is blank
chip.
If the Target MCU is not blank, erase Flash ROM of the Target MCU and
perform the program process.
41