Filter
Top Products
Copyright 2006 Ringdale User Manual, 62-15820000 Page 21 of 28
Legal Notices
FCC Information on the V.90 56Kbps Fax/Modem PC Card
The Federal Communications Commission (FCC) of the United States restricts uses of
modems, and places registration responsibilities on both the manufacturer and the
individual user:
1.The modem may not be connected to a party line or to a coin operated telephone.
2.The modem manufacturer must make any repair to the modem to maintain valid FCC
registration.
3.Notification to the telephone company is no longer required prior to connecting
registered equipment, but upon request from the telephone company, the user shall tell
the telephone company which line the equipment is connected to as well as the
registration number and ringer equivalence number of the registered protective circuitry.
FCC information is printed on a label on the bottom of the modem.
FCC Notice
This equipment has been tested and found to comply with the limits for a digital device,
pursuant to Subpart B and Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates and uses radio frequency energy and if not installed and used the
instructions, may cause interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try and correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
Shielded interconnect cables and a shielded power cord must be employed with this
equipment to insure compliance with the pertinent RF emission limits governing this
device. Changes or modification not expressly approved by the manufacturer could void
the user's authority to operate this equipment.
NOTE: The manufacturer is not responsible for any radio or T.V.
interference caused by unauthorized modifications to this equipment.
Such modifications could void the user's authority to operate the
equipment.