Filter
Top Products
Copyright 2006 Ringdale User Manual, 62-15820000 Page 6 of 28
Installation
The illustration shows the setup of the ports and the diagnostic LEDs.
Connections
See the drawings on page 7 for installation examples.
Plug the PCMCIA modem card into the top slot.
Insert your Ethernet RJ45 connection into the LAN jack on the front.
NOTE: If you do not have your Ethernet connection plugged in, there will be
no lights on power up.
The Modem’s RJ11 phone line cable and adapter will plug into the modem card at
the rear of the unit, with the other end into the RJ11 phone jack on the wall.
Alternatively you may plug the FaxReceiver into a phone splitter.
NOTE: If you daisy chain from an outgoing fax machine, it should be
set to either don't answer or answer after 4 rings or more so that the
fax receiver will pickup first.
Connect the power cord to the Switch Mode Power Supply unit socket.
Plug the AC cord from the Switch Mode Power Supply into the 110V wall socket.
The LEDs are driven by the Ethernet chip so they will only flash if the Ethernet
cable is attached.
Plug the DC wires from the Switch Mode Power Supply unit into the FaxReceiver.
NOTE: It will take about 10 seconds for the FaxReceiver to be ready to
accept a fax or telnet connection.