Filter
Top Products
5-6 Riverstone Networks RS 2100 Getting Started Guide
Loading Software from the Network Managing RS 2100 Software
Here is an example:
6. Enter the set command to view the changes:
Here is an example:
7. From the Boot prompt, use the ping command to verify that the RS 2100 can reach the TFTP server.
8. Reboot the RS 2100. As the RS 2100 initializes, it ignores the software image on the internal flash
and retrieves its operating software from the TFTP server at
134.152.176.5:
Here is an example:
rs-boot> set netaddr <IPaddr>
rs-boot> set netmask <subnet-mask>
rs-boot> set gateway <IPaddr>
rs-boot> set bootsource <dir-filename>
rs-root> set bootaddr <IPaddr>
rs-boot> set netaddr 134.152.179.132
rs-boot> set netmask 255.255.255.224
rs-boot> set gateway 134.152.179.129
rs-boot> set bootsource /tftpboot/ros70
rs-boot> set bootaddr 134.152.176.5
rs-boot> set
...
netaddr = 134.152.179.132
autoboot = boot
netmask = 255.255.255.224
gateway = 134.152.179.129
bootsource = /tftpboot/ros70
bootaddr = 134.152.176.5
ethaddr = 00:00:1d:12:34:56
sysid = -1
rs-boot>
rs-boot> boot
Rebooting. . .
. . .source: tftp://134.152.176.5/tftpboot/ros70
Build location: host 'matrix' by 'adm'...
Version: 7.0.0.0 . . .