Runco VX-44D Projector User Manual


 
Operation
64 Runco VX-44d/-55d Installation/Operation Manual
PRE
L
IMINAR
Y
Memory Presets For each input, the DHD Controller lets you save image quality settings as presets that you
can recall at a later time. You can create up to four presets per input and display mode
(resolution and frame rate).
The DHD Controller stores the following display modes in each memory preset:
•480i
•480p
•576i
•576p
720p/24 Hz
720p/25 Hz
720p/30 Hz
720p/50 Hz
720p/60 Hz
1080i/50 Hz
1080i/50 Hz (Australia)
1080i/60 Hz
1080p/24 Hz
1080p/25 Hz
1080p/30 Hz
1080p/50 Hz
1080p/60 Hz
Use the Memory Presets menu to recall saved image presets, or to save image settings in
the “Custom” or “THX” memory location. The currently-selected preset is indicated by a
” to its left; in the example shown here, ISF Night is selected.
You should save changes to any of the following settings to a preset; otherwise they will
be lost when a new input source or resolution is selected:
•Brightness
•Contrast
Color saturation
•Tint
Sharpness
•Gamma
•Lamp Settings
Color temperature and white balance
To select a memory preset, press or to highlight it and press ENTER.
To save the settings for the current input and display mode to the Custom or THX memory
preset, select it, press
or to highlight Save and press ENTER.
Memory Presets
ISF Night
ISF Day
Custom Save Reset
THX Save Reset
To save the settings for the current input and display mode to the
ISF
Night or ISF Day memory preset, select Save ISF Night or Save
ISF Day from the Calibration menu (refer to Save ISF Night/Save
ISF Day on page 69).
Note