Filter
Top Products
I
NSTALLING
A
N
ETWORK
O
PTION
A.8
Configuring TCP/IP
Your printer can be set up on a variety of TCP/IP networks. There
are two ways that your printer can be assigned a TCP/IP
address, depending on your network:
• Static Addressing: TCP/IP address is assigned manually by
the system administrator.
• Dynamic Addressing BOOTP/DHCP (default): TCP/IP address
is assigned automatically by the server.
Static Addressing
To enter the TCP/IP address from your printer’s control panel,
take the following steps:
1
Press Menu/Exit and then System Setup on the one-
touch dial keypad. SCX-5115 users should press Menu and
then Enter.
2
Press
or
to display “NETWORK SETUP” on the top line.
3
Press or to display “CONFIG NETWORK” on the bottom line.
4
Press Mode/Enter (Enter for SCX-5115) to access the menu.
The first option, “CONFIGURE TCP” displays on the bottom line.
5
Press Mode/Enter (Enter for SCX-5115) to access the menu.
6
Press or until “IP ADDRESS” displays on the bottom line.
7
Press Mode/Enter (Enter for SCX-5115) to access the menu.
8
Press
or
to select IP ADDRESS, SUBNET MASK, or
GATEWAY on the bottom line.
9
Press Mode/Enter (Enter for SCX-5115) to set an address.
A TCP/IP address consists of 4 bytes.
Enter a number between 0
and 255 for each byte.