Filter
Top Products
I
NSTALLING
A
N
ETWORK
O
PTION
A.9
A
10
Enter a number between 0 and 255 for each byte and press
Mode/Enter (Enter for SCX-5115).
You can move between each byte by pressing
or
.
11
Repeat steps 6 through 8 to configure the other TCP/IP
parameters, such as subnet mask and gateway.
12
When you are finished, press Stop/Clear.
Dynamic Addressing (BOOTP/DHCP)
To allow the server to automatically assign the TCP/IP address,
take the following steps:
1
Press Menu/Exit and then System Setup on the one-
touch dial keypad. SCX-5115 users should press Menu and
then Enter.
2
Press
or
to display “NETWORK SETUP” on the top line.
3
Press
or
to display “CONFIG NETWORK” on the
bottom line.
4
Press Mode/Enter (Enter for SCX-5115) to access the
menu.
The first option, “CONFIGURE TCP” displays on the bottom
line.
5
Press Mode/Enter (Enter for SCX-5115) to access the
menu.
6
Press
or
to select the server to assign the TCP/IP
address, DHCP or BOOTP.
7
Press Mode/Enter (Enter for SCX-5115) to save the
selection.
8
When you are finished, press Stop/Clear.