Filter
Top Products
13.5 <
Maintenance>
5 Close the front cover. Make sure that the cover is securely closed.
Replacing the toner cartridge
When the toner cartridge is completely empty:
• Toner Empty appears on the display.
•The Status LED blinks red.
• The machine stops printing. For the SCX-5530FN, incoming faxes are
saved in memory.
At this stage, the toner cartridge needs to be replaced. For order
information for toner cartridges, see page 12.1.
Note
You can set the machine to disregard the Toner Empty
message and to continue printing. See page 13.6.
1 Open the front cover.
2 Pull the toner cartridge out.
3 Remove the new toner cartridge from its bag.
4 Remove the packing tape and roll the cartridge 5 or 6 items to
distribute the toner.
Thoroughly roll the cartridge to assure maximum copies per
cartridge. Save the box and the plastic bag for shipping.
Note
If toner gets on your clothing, wipe it off with a dry cloth and
wash clothing in cold water. Hot water sets toner into fabric.
Caution
Do not touch the green underside of the toner cartridge.
Use the handle on the cartridge to avoid touching this area.
5 Hold the toner cartridge by the handle and slowly insert the cartridge
into the opening in the machine.
Tabs on the sides of the cartridge and corresponding grooves within
the machine will guide the cartridge into the correct position until it
locks into place completely.
6 Close the front cover. Make sure that the cover is securely closed.
Cleaning the drum
If there are streaks or spots on your print, the OPC drum of the toner
cartridge may require cleaning.
1 Before starting the cleaning procedure, make sure that paper is
loaded in the machine.
2 Press Menu until System Setup appears on the bottom line of the
display and press OK.
3 Press the Scroll buttons until Maintenance appears and press OK.
4 Press OK when Clean Drum appears.
The machine prints out a cleaning page. Toner particles on the drum
surface are affixed to the paper.
If the problem remains, repeat steps 1 through 4.