Filter
Top Products
3. Display Adapter Driver
Display adapter refers to the computer video card driver. If the adapter is not properly set, you cannot
adjust resolution, frequency or color and you cannot install the monitor driver.
1. Checking Adapter Driver
Click Start --> Settings --> Control Panel --> Display --> Settings --> Advanced --> Adapter.
If "Default" or a wrong product model is indicated, it means that the adapter driver is not properly
installed. Install the adapter driver again according to the information provided by the computer or
video card manufacturers.
2. Installing Adapter Driver
The instructions given below are for general circumstances. For specific issues, contact the
relevant computer or video card manufacturers.
1) Click Start --> Settings --> Control Panel --> Display --> Settings --> Advanced --> Adapter -->
Update Driver --> Next --> Display a list of the known drivers for this device so that I can
choose a specific driver --> Next -> Have Disk (Insert Video Card Driver diskette) -> OK -> Next
-> Next -> Finish.
2) In case you have Adapter Driver Setup file on your computer:
Run Setup.exe or Install.exe, which is found in the Adapter Driver Setup file.
4. Maintenance and Cleaning
1. Maintaining the Monitor Case
Clean with a soft cloth after disconnecting the power cord.
2. Maintaining the Flat Panel Display Screen
Clean with a soft cloth (cotton flannel) smoothly.
z Do not use benzene, thinner or other flammable substances, or a
wet cloth.
z We recommend a Samsung cleansing agent is used to prevent
damage to the screen.
z Never use acetone, benzene or thinner.
(They may cause flaws or deformation of the screen surface.)
z The user will be required to pay costs and related expenses for
repair of damages caused by him/her.
5. Symptoms and Recommended Actions
A monitor recreates visual signals received from the PC. Therefore, if there is trouble with the PC or the
video card, this can cause the monitor to become blank, have poor coloring, noise, Video mode not
supported, etc. In this case, first check the source of the problem, and then contact a service center or
your dealer.
1. Check if the power cord and the cable are properly connected to the computer.
2. Check if the computer beeps more than 3 times when booting.
(If it does, request an after-service for the main board of the computer.)
3. If you installed a new video card or if you assembled the PC, check if the installed the adapter
(video) driver and the monitor driver.
4. Check if the scanning ratio of the video screen is set at 75Hz.
(Do not exceed 60Hz when using the maximum resolution.)
5. If you have problems in installing the adapter (video) driver, boot the computer in Safe Mode,
remove the Display Adapter at the "Control Panel, System, Device Administrator" and then
reboot the computer to reinstall the adapter (video) driver.