Filter
Top Products
20
Chapter 2 Installation
Connection of LAN cable
To connect to the network, it is required to use the UTP (Unshielded Twisted Pair) straight cable
with RJ-45 plug. There are two different types of cables depending on whether the network is
constructed with 10Base-T or 100Base-TX. Prepare the Hub (10Base-T or 100Base-TX) to distrib-
ute the network cable if required.
1 Disconnect the AC plug from the monitor.
2 Connect the UTP straight cable to the LAN port on the network unit.
3 Connect the UTP straight cable to the hub.
The AC cord must be disconnected from AC power outlet when connecting the cable. It may
damage the product.
When you set up the network which has a default setting by using computer, it must be carried
out in the network which does not connect to other monitors.
Use the UTP cross cable when you connect the computer and monitor directly not using the hub.
When you connect the monitor into the 10Base-T network, use cable with category 3 or 5. When
you connect the monitor into the 100Base-TX network, use cable with category 5.
The length of cable between hub and monitor should be less than 100m.
Hub
(10Base-T, 100Base-TX)
UTP straight cable
Monitor