35
LD-NET ORGANIZER
OWNER'S MANUAL
Network PIN code setting
This is to set the Network PIN code to restrict the access from
an unauthorized person through the network.
Enter a 4-digit number as the Network PIN code onto the text
box and click Set button.
The network unit begins restarting and it takes about 20 sec
-
onds. Close (Quit) the web browser and access to the login
page again in 20 seconds. This is to perform the login authentication firmly.
The default Network PIN code [0000] means no Network PIN code is set.
When you connect the monitor with this product to the network, it is recommended to set a new
Network PIN code. Only a four-digit number is valid for the Network PIN code.
Valid characters for the Network PIN code are only numbers 0 to 9. The number "0000" means no
Network PIN code is set.
This Network PIN code is not to restrict the use of the monitor. This Network PIN code is to set the
security against the use of the monitor through the network.
If you forget the Network PIN code to the monitor, you can initialize PIN code and IP Address/Sub
net/Gateway/DNS by selecting "Network initial" from "Installation mode" menu on the monitor.
For further information, please see instruction manual of the monitor.
Initial setting