Filter
Top Products
Unit 3: Installation
CL408-412e Supplemental Manual
3-14 PN: 9001159A
802.11G WIRELESS
The wireless print server provides easy printer interface with 802.11G Wi-Fi compliant networks free of wired
connections. Each printer is shipped with an integrated driver and interface installed. The driver must be loaded
onto the host computer and configured to run one of the supported protocols.
SPECIFICATIONS
Variable Data Rates 54, 11, 5.5, 2 and 1 Mbps
Frequency Band 2.4 GHz ISM Band
Wired Equivalent Privacy 128 bit, 64 bit (compatible with 40bit), WPA, none
Sensitivity (typ, AAWGN, 8E-2 PER): -91dBm at 1Mbps, -88dBm at 2 Mdps, -87dBm at 5.5Mbps, -
84dBm at 11Mbps.
Range 100m indoors, 300m outdoors
Protocols TCP/IP, IPX/SPX, Direct Mode IPX/IP, DLC/LLC, NetBEUI, NetBIOS/IP
Protocol Status3 return
Protocol for Driver (cyclic response mode)
Protocol for Driver (ENQ response mode)
Status5 return
IP Address 0.0.0.0 to 255.255.255.255
Subnet Mask 0.0.0.0 to 255.255.255.255
Gateway Address 0.0.0.0 to 255.255.255.255
Communication Mode 802.11 Ad hoc, Ad hoc, Infrastructure
SSID Optional alphanumeric character string (up to 32 characters)
Channels 01 to 11
DIPSWITCH SETTINGS
The dipswitches serve to initialize the configuration saved on the Wireless-LAN board, print the configuration, and make a self-
diagnosis. To communicate with the host,set the communication mode by through switches 5 and 6, then set the remaining
switches to the OFF position.
Print of configuration and self-diagnsis are operable only on the screen after turning on the printer. Ensure all switches are in
the OFF position when operating the printer.
SWITCH SETTING
1 Reserved for test use only (setup prohibited).
2 LAN board EEPROM initialization (initialize configuration).
3 Print configuration details on a label (diagnostic & configuration).
4 Print a self-diagmosis of the board onto a label (wireless mode).
NOTE: The communication mode may be set within the printer’s Interface Mode. Go to [Communication] of the Interface Mode
to enable setup by either the dipswitches or through the Interface Mode.
LED INDICATOR STATUS
INDICATOR 1 INDICATOR 2 INDICATOR 3 DESCRIPTION
ON OFF OFF Weak Signal (1-50%)
ON ON OFF Moderate Signal (50-75%)
ON ON ON Strong Signal (75-100%)
OFF OFF ON 802.11 Ad hoc
OFF ON OFF Ad hoc