Filter
Top Products
Unit 4: Printer Configuration
GL408-412e Operator Manual
4-64 PN: 9001163A
This menu selects the character set used by the printer.
Provides access to the desired character set.
Lines Per Inch. This menu allows the quantity of lines that will be printed in a linear inch to be
selected. Example: at 6 LPI, there is 1/6 inches from the top of one line to the top of the next.
The allowable options are 6.0, 8.0, and 10.3 LPI. The factory default is 6.0 LPI.
This menu controls the action of the printer when it receives a Carriage Return code (0D Hex)
from the host computer. If this feature is enabled, each time the printer receives a carriage return,
it inserts an additional Line Feed code (0A Hex) into the data stream. Do not use this feature if the
host computer sends line feeds to the printer.
• CR = CR - factory default. Does not insert an extra line feed after each carriage return.
• CR = CR + LF - inserts an extra line feed after each carriage return. The next print position
will be print position 1 of the next line.
Note: For this menu to take effect in PGL, PGL Normal must be set to PGL Menu.
This parameter forces the printer to insert an automatic Carriage Return code into the data
stream whenever a Line Feed code occurs. This can be used in most installations, but is required
if the host computer does not send carriage returns to the printer.
• LF = LF - factory default. Does not perform an automatic carriage return. The next print
position will be at the current print character position on the next line.
• LF = CR + LF - performs an automatic carriage return. The next print position will be print
position 1 of the next line.
Note: For this menu to take effect in PGL, PGL Normal must be set to PGL Menu.
This parameter determines if text will wrap to the next line when the line of text exceeds the right
margin.
• Disable - factory default. Truncates the text beyond the right margin until a CR or CR + LF is
received.
• Enable - automatically inserts a CR + LF after a full print line.
This parameter enables the printer to print text in all uppercase when using the ALPHA
command.
• Disable - factory default. Will print in upper and lowercase.
• Enable - will print text only in uppercase.
This parameter allows printing the zero numeral with or without a diagonal slash through it. This
option applies to all character sets except OCR-A and OCR-B.
• Disable - factory default. Zero will be printed without a slash.
• Enable - zero will be printed with a slash.
PGL EMULATION MODE (TABLE 4-10)
MENU DESCRIPTION
Character Group
Standard Sets*
Standard Sets
0) ASCII*
Select LPI
6*
Define CR Code
CR= CR*
Define LF Code
LF= LF*
Autowrap
Disable*
Auto Uppercase
Disable*
Slash 0
Disable*