Filter
Top Products
Unit 4: Printer Configuration
GL408-412e Operator Manual
4-62 PN: 9001163A
Power Management. This menu allows the power-save and sleep modes to be set. The value set
wil be in milliseconds. If set to zero, the power-save mode will be disabled.
The allowable range is 0 to 1000 ms., and the factory default is 0 ms..
Allows the transmission power to be set as a percentage of full power capabilities.
The allowable range is 0 to 100%, and the factory default is 100%.
International Mode. Allows the determination of whether the wireless option adapts to
international frequency requirements in Europe.
• Disable - factory default. Conforms to European standards.
• Enable - does not conform to European standards.
Authentification Method. Allows the authentification method used for the wireless network
interface to be selected.
• Open - factory default. Provides open authentification.
• Shared - provides shared key authentification.
Allows all four WEP keys to be simultaneously reset.
Allows which WEP Key will be formatted in the following menus.
Is a transitional menu screen that wil lead to menu screens that will allow the WEP Key to be
formatted.
Allows WEP Key input format to be selected.
• Hexadecimal - factory default. Valid characters are 0 to 9 and A to F (upper case only) with a
maximum of 32 characters.
• ASCII - allows for alphanumeric characters to be used with a maximum of 16 characters.
Allows the operator to select the width of the key desired.
• 128 Bits - factory default. 32 Hex values or 16 ASCII characters.
• 40 Bits - 10 Hex values or 5 ASCII characters.
Enables the encryption (scramble) of information for security purposes. Up to four encription keys
may be set in either ASCII or hexdecimal format, and in either 40 or 128 bits. The mode bits
chosen, the greater the difficulty of decoding the information.
Note: None of the WEP Key Configuration menus display on the configuration printout.
WIRELESS LOCAL AREA NETWORK (WLAN) INTERFACE MODE (TABLE 4-9)
MENU DESCRIPTION
Power Mgt
0 ms. *
Transit Power
100% *
Internat. Mode
Disable*
Auth Method
Open*
WLAN SETTING
Reset WEP Keys
WLAN SETTING
WEP Key X
WEP Key X
Key Format
Key Format
Hexadecimal *
Key Width
128 Bits *
Byte XX
00 *