Filter
Top Products
Unit 4: Printer Configuration
GL408-412e Operator Manual
4-56 PN: 9001163A
This menu allows the IP Address to be set for the TCP/IP protocol in four three-digit segments
(SEG1 through SEG4). If the IP Address is assigned by Bootp, ARP, or DHCP it is dynamic and
read only.
The factory defaults for SEG1 through SEG4 are 000, 000, 000, and 000.
Note: When changing the IP Address, the printer resets the Network Interface Card (NIC) when
the printer is placed online. When the printer resets the NIC, the LCD displays DO NOT POWER
OFF. After the NIC has completed initialization, the LCD displays E-NET INIT to signal that the
NIC andd printer are in initialization process. When both the NIC and printer have completed the
initialization, theLCD displays E-NET READY.
Allows the Subnet Mask to be set for the TCP/IP protocol in four three-digit segments (SEG1
through SEG4). If the Subnet Mask is assigned by Bootp, Arp or DHCP, it is dynamic and read
only.
The defaults for the SEG1 through SEG4 are 000, 000, 000, and 000.
Note: When changing the Subnet Mask, the printer resets the NIC when the printer is placed
online. When the printer resets the NIC, the LCD displays DO NOT POWER OFF. After the NIC
has completed its initialization, the LCD displays E-NET INIT to signal that the NIC and printer are
in the initialization process. When both the NIC and printer have completed initilization, the LCD
displays E-NET READY.
Allows the Gateway Address to be set for the TCP/IP protocol in four three-digit segments (SEG1
through SEG4). If the Gateway Address is assigned by Bootp, ARP, or DHCP, it is dynamic and
read only.
The defaults for the SEG1 through SEG4 are 000, 000, 000, and 000.
Note: When changing the Gateway Address, the printer resets the NIC when the printer is place
online. When the printer resets the NIC, the LCD displays DO NOT POWER OFF. After the NIC
has completed its initialization, the LCD displays E-NET INIT to signal that the NIC and printer are
in the initialization process. When both the NIC and printer have completed initialization, the LCD
displays E-NET READY.
This is an informational screen that displays the manufacturer’s assigned number. This number is
unique for each NIC.
Allows the DHCP protocol to be enabled or disabled through this menu.
The factory default is Disable.
Note: Consult with your systems administrator for the appropriate setting.
WIRELESS LOCAL AREA NETWORK (WLAN) INTERFACE MODE (TABLE 4-9)
MENU DESCRIPTION
Permits entry into the INTERFACES Mode.
LOCAL AREA NETWORK (LAN) INTERFACE MODE (TABLE 4-8)
MENU DESCRIPTION
IP Address
XXX.XXX.XXX.XXX
Subnet Mask
XXX.XXX.XXX.XXX
Gateway Address
XXX.XXX.XXX.XXX
MAC Address
XXX.XXX.XXX.XXX
DHCP
Disable*
INTERFACES