Filter
Top Products
Installation
16
35011984 02/2006
Installation Requirements
Installation
Requirements
list
Installation requirements are as follows:
z Microsoft Windows XP Operating System with Service Pack 2 or greater installed
(Windows 2000 with Service Pack 4 or greater can also be used on most
computers),
z 1 MB free disk space,
z at least 256 MB RAM,
z at least one free USB port or a USB Hub supporting USB 1.1 or greater.
Upgrading From Previous Version
Introduction Currently, if a previous version of the TSXCUSBMBP Driver has been installed, the
Virtual Serial Port component of the driver must be manually uninstalled using
Device Manager before a new version can be installed.
How to uninstall
the Virtual Serial
Port?
These steps must be followed to uninstall the Virtual Serial Port from your system.
Step Action
1 Close any software applications using the TSXCUSBMBP Driver.
2 Exit the TSXCUSBMBP Driver by right clicking on the Icon at the bottom then
selecting Exit Driver.
3 Unplug the USB Modbus Plus Device from the USB port on the computer (or USB
Hub if using one).
4 Start up the Windows Device Manager.
On most systems, this is done by the following steps.
z Open Control Panel, System, Hardware, then Device Manager.
z In Device Manager, left click on the + next to ABT Virtual Device. Virtual Serial
Port will now appear underneath ABT Virtual Device.
z Right click on Virtual Serial Port and select Uninstall.
z When prompted, confirm the device removal.
z After ABT Virtual Device disappears from the list, close the Device Manager.