Filter
Top Products
44
13. FDR service
13. 3. Downloaded configuration
If the drive parameter configuration has been downloaded, the FDR server assigns:
M The IP addresses
• Card IP address.
• Subnet mask.
• Gateway IP address.
• FDR server IP address.
M Drive parameters (configuration)
b First use
Procedure:
• Configure the drive.
• Turn off the drive.
• Connect the drive to the network.
• Configure the FDR server (see the PLC manual).
• Supply the FDR server with the configuration file.
• Check that the system is operational.
In the procedure described below, the configuration file is supplied to the FDR server, via the Ethernet network, using a save command
performed on the drive graphic display terminal.
Note: This procedure can also be performed using a web browser, which is more user-friendly than the drive graphic display terminal
(see the “Standard web server” section).
M Configure the drive
In the [1.9 - COMMUNICATION] (COM-) menu, [ETHERNET] (EtH-) submenu:
• Leave the IP address [IP card] (IPC1) (IPC2) (IPC3) (IPC4) at the value [0.0.0.0] (0) (0) (0) (0).
• Enable the FDR service: [FDR validation] (FdrU) = [Yes] (YES).
• Caution, before the first connection, you must select local drive configuration: [FDR Local Config.] (LCFG) = [Yes] (YES).
The drive must first supply the configuration to the server.
If this option is not selected, an invalid or null configuration file may be uploaded to the FDR server. Subsequent drives would then receive
incorrect configuration files, leading to unexpected behavior.
Enter the device name, [DEVICE NAME], in the [7. DISPLAY CONFIG.] menu, [7.1 USER PARAMETERS] submenu.
This menu can only be accessed in expert mode: In the [2 ACCESS LEVEL] (LAC-) menu, set the level to [expert]
(EPr).
M Turn the drive off and then back on again
Turn the drive off and then back on again (control voltage if a separate power supply is being used), otherwise the device name is not taken
into account.
M Connect the drive to the network
DANGER
UNINTENDED EQUIPMENT OPERATION
Ensure that the local configuration option [FDR Local Config.] (LCFG)=[Yes] (YES) is selected when configuring the first drive.
Failure to follow this instruction will result in death, serious injury, or equipment damage.
IP assignment
Save
Downloading