Filter
Top Products
8 Unpacking and Installation
3 UNPACKING AND INSTALLATION
Please read and fully understand the entire manual before proceeding to use your
laminator.
3.1 Ambient Conditions
The following environmental conditions are ideal for the best operation of the laminator.
Ambient Temperature
The best temperature for the 44/62 Ultra Plus is between 16°C and 35°C (50°F and 95°F).
Do not expose the laminator to direct sunlight as output quality may be affected.
Relative humidity
For best results, the ambient relative humidity for the 44/62 Ultra Plus should lie between
70% and 90%.
Water and moisture
If the laminator is installed in a damp room or near water, the electrical power supply must
be in accordance with the standards prevailing in the country concerned.
3.2 Surroundings
Install the laminator in surroundings that are as clean and dust free as possible in order to
obtain the highest quality end product. The materials that are used on this laminator can
have an electrostatic charge and will attract dust, adversely affecting the output.
3.3 Power supply
Connect the machine in accordance with the details given on the identification plate
attached to the rear of the machine. Refer also to the technical specifications in this
section for more information.
3.4 Workspace Requirements
This unit should be situated away from heat sources such as heat registers or stoves.
The laminator’s location or position should not interfere with its proper ventilation.
There should be enough space around the laminator to feed-in, exit, and trim mounted
and/or laminated images.
The background dust level must not exceed that found in a typical office/computer room
environment.
The work area should be level, flat, and well lit.