Filter
Top Products
Application Processes 27
English
6.10 Mounting and Lamination using a ProSEAL
®
pouch Board.
1. Refer to the instruction sheet packed with each box of ProSEAL Pouch Boards for
specific instructions on mounting/laminating with a ProSEAL Board.
2. Also, refer to the instruction sheet for information on Compatible Media, Process
Conditions and Technical Information.
3. A ProSEAL Pouch Board consists of a SEAL foam board mounting board with a piece
of film on top. The film is sealed to the board along one of the short sides. Carefully
examine the board to deter-mine which edge is sealed. Starting at one of the corners,
opposite the sealed edge, gently lift and peel back the film. Care should be taken not
to break the sealed hinge.
4. Center the image to be laminated on the board and lay the film back over it.
5. Set the Control Knob to the correct setting that matches the Pouch Board thickness.
6. Slowly insert the Pouch Board into the inlet opening. Ensure that the Pouch Board will
enter centered and straight. A gentle push may be required to start the board into the
machine. Hold the edges of the Pouch board until it is engaged and the laminator
begins pulling it on its own.
7. The Pouch Board will feed through the Laminator and automatically exit at the rear of
the unit.
8. CAUTION! The pouch board will be hot!
Allow it to lie flat while cooling.
Note:
If there is any dirt or adhesive on the surface of the board, it can be removed by
dampening a lint free cloth with ISO Propyl Alcohol (IPA) and wiping the surface.
WARNING:
ALWAYS USE CARE WHEN USING IPA! IPA IS VERY FLAMMABLE!
THE FLASH POINT OF IPA IS 11°C (51.8°F). THE SELF-IGNITION
TEMPERATURE IS 400°C (752°F).