Filter
Top Products
Application Processes 17
English
6 APPLICATION PROCESSES
6.1 Loading the machine
The following steps outline the basic procedure that have to be used for loading materials,
webbing the laminator and setting the brake tension for the materials you will be using. To
load and unload the material shafts, it is necessary to access the machine from the rear
side.
Select the film(s) that you will use on the top (and bottom) of the images, it is advisable to
use slightly wider width films compared to the print width. This way the print can be
trimmed with a border, so as to reduce waste, but be enough to leave a border.
Always work in the center of the machine.
Check which temperature setting has to be used for your materials. (see figure 10)
Figure 11
6.1.1 Loading film onto a machine equipped with the interlock bracket.
• Remove the desired supply shaft (top or bottom) by pushing the interlock bracket (1) in
the upper position and sliding the autogrip shaft to the right against the spring
pressure.
• Release the interlock bracket when the shaft is completely to the right.
• Lift the shaft out of the laminator.
• Slide the shaft into a material roll. Ensure that the rubber blocking cords are on the top
and bottom of the shaft for easy loading.
1