Filter
Top Products
Unpacking and Installation 11
English
Your 44/62 Ultra Plus must be setup at the place where it will be used. The stand must be
placed on a flat level surface.
12. Cut the tie-wraps and remove the blocks that hold the top roller.
13. Inspect the machine for any physical damage.
14. Plug the power cable into the grounded outlet with appropriate service.
The machine must be installed next to an outlet! Do not use extension cords. The plug
and the outlet must be easily accessible. Please ensure that you plug your laminator into a
grounded, three-prong outlet. Please ensure that the total load of the other items using the
same circuit breaker do not exceed its breaking value.
The laminator should only be connected to a power supply outlet of the voltage and
amperage marked on the rear panel. The laminator has a grounded plug (three prongs).
To reduce the risk of electrical shock, this plug is intended to fit only a grounded outlet
of the proper amperage, and in only one way.
3.5.1 Adjustable feet
To secure the stand on the floor, turn the adjustable foot down by hand, until it’s pressed
against the floor. Manually lock the adjustable foot with the nut (figure 6).
Figure 6
Feet
Nut