Filter
Top Products
Maintenance & Cleaning 29
English
7 MAINTENANCE & CLEANING
Cleaning of the Machine
The equipment must be disconnected from the mains before cleaning.
The laminator may be cleaned by the operator with a lint-free cloth, lightly dampen with a
mild soap and water solution. Spray-on cleaners are not to be used. No part of the
machine is to be immersed in water or other liquids.
Do not use an abrasive cleaner, which can damage the painted surfaces.
Do not allow water or liquids to enter the electrical circuits, which may cause personal
injury and / or damage the equipment when power is applied.
Cleaning the roller procedure: Use the Image roll-cleaner to remove the excess adhesive
from the rollers. This is best done with the rollers hot. When cleaning the upper roller,
place a piece of scrap foam board under the roller to prevent the removed adhesive
remnants from falling onto the lower roller.
Note:
For adhesive that is difficult to remove, allow the rollers to cool and use isopropyl
alcohol (IPA) and a clean, lint-free cloth. Never pour isopropyl alcohol (IPA) directly
onto the unit.
WARNING:
ALWAYS USE CARE WHEN USING IPA! IPA IS VERY FLAMMABLE!
THE FLASH POINT OF IPA IS 11°C (51.8°F). THE SELF-IGNITION
TEMPERATURE IS 400°C (752°F).