Filter
Top Products
Installing the paper rack
1. Slide both paper guides to the
extreme left and right edges of the
paper rack.
2. With the two small pivots on either
side of the paper rack downward, fit
the pivots in the groove on the rear
top cover.
3. Place the paper rack in upright
position for single cut sheet paper
and lay it down for fanfold
continuous paper.
Installing the sound seal cover
1. Lay the sound seal cover upside
down on the printer.
2. Fit one of the holes of the cover to
the stud of the L-angle hinge on one
side of the printer.
3. Fit the other hole to the other stud
by pressing the L-angle hinge
inward then out through the hole.
Note
The paper guides should be placed to the outside edges during
the installation or removal of the paper rack.
Note
Make sure that both studs are out through the hole completely,
otherwise, the sound seal cover will be stuck in place.
Rear Top Cover
1
2
Pivots
Groove
L-angle Hinge
10
2. Setting up
2. Setting up