Filter
Top Products
33
PRINTER KEY OPERATOR PROGRAMS
The following programs can be selected only if an optional power
supply kit and an optional printer controller have been installed. Select
“PRINTER” after entering the key operator code number. Then select
the desired program.
Enable Bypass-Tray Size Detection
This program is used to enable or disable paper size detection of the
bypass tray in the print mode. This setting does not affect the paper
size detection in the copy mode.
●
When the check mark is on, automatic size detection is enabled for
the bypass tray and the tray is included as an alternative for auto tray
switching for the print mode.
●
When the check mark is off, the bypass is not included as an
alternative for automatic tray switching and the paper in the bypass
tray is always defined as special paper.
To enable paper size detection of the bypass tray in the print
mode, press the “ENABLE BYPASS-TRAY SIZE DETECTION”
box to display a check mark.
To disable paper size detection, press the checked box again
to clear the check mark.
NOTE:
If images larger than the paper in the bypass tray are printed, the toner
image outside the paper area will be wasted and will tend to dirty some
machine parts. After disabling the size detection, be careful to print
images that are the same size or smaller than the paper used.
Enable Bypass-Tray Type Detection
This program is used to ensure that the paper type selected for copying
and printing are the same.
●
When the check mark is on, the paper types selected for copying
and printing will be compared. These must be the same for automatic
paper feeding to function.
●
When the check mark is off, the settings for copier and printer can
be different and will not be compared. When the settings are
different, a selection from the printer driver will override any selection
made at the copier. When printing with the check mark off, make
sure to select the correct paper type. Selecting a wrong paper type
might cause a misfeed or other malfunction.
To enable paper type detection of the paper tray, press the
check box of “ENABLE BYPASS- TRAY TYPE DETECTION”
to display a check mark.
To disable it, press the checked box again to clear the check
mark.
KEY OPERATOR PROGRAMS