Sharp AR-M351U AR-M451U AR-M351N AR-M451N Printer User Manual


 
SADDLE STITCH FINISHER
3-21
3
9
Turn roller rotating knob A in the direction
of the arrow to move the staple unit to the
front.
Turn the roller rotating
knob until the triangle
mark is aligned with the
index.
10
Remove the staple box.
11
Raise the lever at the end of the staple box.
Remove the top staple if
it is bent. If bent staples
remain, a staple jam will
occur again.
12
Return the lever to its original position.
13
Reinstall the staple box.
Push the staple box in
until it clicks into place.
14
Push the stapler section back into the finisher.
15
Close the front cover.
16
Push the saddle stitch finisher back against the
machine.
Disposal of hole punch scrap
1
Unlatch the saddle stitch finisher and slide
it away from the machine.
2
Pull out the punch scrap collecting
container and empty it.
Empty the punch debris
into a plastic bag or
other container for
disposal, taking care not
to spill any of the punch
debris.
3
Return the punch scrap collecting
container to its original position.
4
Push the saddle stitch finisher back
against the machine.
Staple unit
Roller rotating
knob A
NOTE
Make a test print or copy in the staple sort mode to
ensure that stapling is performed properly.
Copy_EX.book 21 ページ 2004年9月28日 火曜日 午後9時54分