Filter
Top Products
Network Scanner Tool User’s Guide 21
Enable/Disable a Copier
You can enable or disable a copier for scanning to your computer by checking or unchecking the
box next to the copier name.
Auto Detect
This option will cause Network Scanner Tool to search the local subnet for Sharp copiers that are
capable of network scanning. The local subnet consists of those IP addresses that have the first
three segments in common. Any copier that is found will be listed but not enabled. Once detected
and listed, you need to check the ones you would like to use with Network Scanner Tool.
Web Setup
[Note that an administrator login might be required.]
This option lets you use a copier’s web page to change its configuration values. These pages are
accessible by selecting a copier from the list and then by pressing the Web Setup button. Adding or
deleting profiles with the web page will not update the listing of process definitions used by your
computer’s Network Scanner Tool. This is not recommended.
Apply Changes
This option automatically updates the selected copier(s) with the destination for the selected
process definition. This information stays on the same screen.
Ok Changes
This option works in the same manner as Apply, but changes the screen.
Cancel Changes
This option lets you eliminate any changes that you have made since the last time you pressed
Apply or OK.