Filter
Top Products
TROUBLESHOOTING AND MAINTENANCE
76
Paper size for a paper
tray cannot be set.
Copying or printing is performed.
→
→ →
→ Set the paper size after copying or
printing is complete.
-
The machine has stopped temporarily
due to running out of paper or a
misfeed.
→
→ →
→ Load paper or remove the misfeed, and
then set the paper size.
23, 80
A copy job stops before
it is finished.
"MEMORY FULL, PRESS START TO
RESUME." appears in the display.
→
→ →
→ The memory became full during sort.
Copy only the originals that have been
scanned to that point, or cancel the job
and clear the data from memory.
34
The tray is out of paper.
→
→ →
→ Load paper.
19
The power save
indicator is lit.
Other indicators are lit.
→
→ →
→
If other indicators are lit, the machine is
in preheat mode. Press any key on the
operation panel to resume normal
operation.
17
Only the power save indicator is lit.
→
→ →
→ If only the power save indicator is lit, the
machine is in auto power shut-off
mode. Press the [START] key ( ) to
resume normal operation.
17
Error indicator ( ) is
lit or blinking.
See "DISPLAY MESSAGES" to check
the meaning of the error indicator and
error message in the display, and take
appropriate action.
71
Copies made using the
RSPF are dirty.
The underside of the RSPF is dirty
→ Clean the underside of the RSPF
(especially areas where black lines
appear).
88
Lighting fixture flickers.
The same power outlet is used for the
lighting fixture and the machine.
→
→ →
→
Connect the machine to a power outlet
which is not used for other electric
appliances.
-
Problem Cause and solution Page