Filter
Top Products
RightFax MFP Module 2.5 Guide for the Sharp Extension 10
RightFax Server Support and Requirements
All RightFax servers that will be used for sending faxes from Sharp
devices must be version 9.0 or higher. Microsoft Internet Explorer
version 6 is required on all RightFax servers.
The repository folder where outbound faxes originating from the
Sharp device will be placed must be configured as an FTP site on
an IIS server on your network. Before you begin, ensure that the
FTP component is installed on the IIS server you want to use. You
should also add a subfolder called Sharp under the
\Inetpub\ftproot folder on the IIS server. This will be used as the
repository folder.
If you are upgrading from an earlier version
of the External Document Connector
Installing the RightFax MFP Module will overwrite all earlier
versions of the RightFax External Document Connector (EDC) for
Sharp extensions, discarding any existing configuration settings.
Captaris strongly recommends that you write down or take
screenshots of the existing configuration settings before installing
the RightFax MFP Module. Many of these settings will be reused
with the RightFax MFP module and information about your existing
EDC settings will simplify the process of configuring the new
module.
Sharp MFP Support and Requirements
The RightFax MFP Module supports the following Sharp models:
AR-M350N
AR-M450N
AR-M550N
AR-M620N
AR-M700N
Important Your Sharp device includes configuration software can be
accessed via a Web browser. To access this software, you must know the
IP address of the Sharp device. If you have not already set up the Sharp
device so that this software is accessible you should do so now.
Install the RightFax MFP Module
To install the RightFax MFP Module, you must complete the
following steps:
1. Download the RightFax MFP Module (described on page 11)
2. Run the RightFax MFP Module installation (described on
page 11)
The MFP Module installation program copies the module’s files to
the RightFax server and lets you configure some of the settings
required to integrate RightFax with your Sharp MFPs.
Important information about installations and upgrades
Do not re-run this installation if you have already installed this
version of the MFP Module or if you have installed any other
RightFax products which use the same installation architecture as
this product. Doing so will detect the existing installation and offer
the options Repair and Uninstall. Selecting Repair will cause any
existing configuration settings to be overwritten with default
settings. If you have already installed this product or any of the