-30
Image Projection
-30
Basic Procedure
Connect the required external equipment to
the projector before operating the following
procedures.
Info
•
The language preset at the factory is English.
If you want to change the on-screen display
to another language, reset the language ac-
cording to the procedure on page 31.
1 Plug the power cord into the
wall outlet.
•The POWER indicator illuminates red,
and the projector enters standby mode.
2
Press on the remote control
or
on the projector.
•The blinking green LAMP indicator
shows that the lamp is warming up.
Wait until the indicator stops blinking
before operating the projector.
•If the power is turned off and then im-
mediately turned on again, it may take
a short while before the lamp turns on.
Note
•After the projector is unpacked and
turned on for the first time, a slight
odour may be emitted from the ex-
haust ventilative holes. This odor will
soon disappear with use.
When the power is on, the LAMP in-
dicator illuminates, indicating the sta-
tus of the lamp.
Green: Lamp is ready.
Green blinking:
Warming up. / Cooling
down.
Red: Change the lamp.
TEMP. LAMP POWER
LAMP indicator
POWER indicator
ON button
INPUT button
ON button
INPUT buttons
XV_Z200E_E_p29_43.p65 03.10.30, 13:14PM30