Filter
Top Products
-60
Lamp
unit
BQC-XVZ200++1
Removing and Install-
ing the Lamp Unit
Caution
• Be sure to remove the lamp unit by the handle.
Do not touch the glass surface of the lamp
unit or the inside of the projector.
• To avoid injury to yourself and damage to the
lamp, carefully follow the steps below.
• Replace the lamp after turning off the power
and unplugging the power cord.
1 Put the projector into the
standby mode.
•Press .
•Wait until the cooling fan stops.
2 Unplug the power cord.
•Unplug the power cord from the AC
socket.
•Leave the lamp until it has fully cooled
down (about 1 hour).
3 Remove the Swivel Stand. (See
page 24.)
4 Remove the lamp unit cover.
•Loosen the user service screw that se-
cures the lamp unit cover.
•Slide the lamp unit cover in the direc-
tion of the arrow.
5 Remove the lamp unit.
•Loosen the securing screws from the
lamp unit. Hold the lamp unit by the
handle and pull it in the direction of
the arrow.
User service
screw
Regarding the Lamp
STANDBY button
Power cord
-60
XV_Z200E_E_p57_66.p65 03.10.30, 13:15PM60