Filter
Top Products
[ Installation ]
23
Convertible Antenna Cable Routing Procedure
Figure 14 shows how the antenna cable should be routed from the antenna to the
dock in a convertible. The exact routing of the antenna cable may vary depending upon
where you have installed the dock in your vehicle. Avoid side airbag locations on back
pillars and above the doors. (Airbag locations are marked with “SRS” logos.)
6. Bring Cable Out To
Docking Station
Location and Connect
to the Docking Station
1. Bring Cable from
Antenna Into Inside
of Trunk Lid
2. Tape Cable Along
Inside of Lid to
Hinge Strut
4. Route Cable from Trunk
Under Interior Trim, into
Cabin and Towards Front
of Vehicle
5. Bring Cable out from
Trim and Route Under
Carpet to Dashboard
or Console.
3. Tie Cable to Hinge Strut, Allowing
Slack for Lid to Open and Close.
Route Cable Into Cabin
Through Existing Wire
Channel.
Figure 14Figure 14