Filter
Top Products
Page 35 of 80
intelligent wireless platform
airHaul™ Nexus User Guide
2.7. Remote Bridge Configuration
The airHaul units can also be configured to operate as a Remote device to associate with Root
Bridge. In Remote mode, the unit can operate as a bridge or a router.
Follow the steps in section 2.7.1 to 2.7.5 to configure the device in Remote Bridge mode
.
2.7.1 Ethernet Configuration
The Ethernet IP is configured during the operational mode change to Remote Bridge mode.
Follow these steps below if you need to re-configure the Remote Bridge Ethernet parameters:
1. From the Summary Information page, click on the Ethernet Configuration link to change
Ethernet parameters.
2. Enable or disable the DHCP by clicking the check box. Enter the ‘IP address’, ‘IP mask’,
‘Gateway’ for non DHCP. Give the unit a unique IP Address on the same IP subnet (e.g.
192.168.0.100) as the Root Bridge unit.
3. Click on the ‘Apply Changes’ button to change the settings.
Figure 2-20 Remote Bridge Ethernet Configuration