Filter
Top Products
ENGLISH
Bed scale 7711
22
■ Print
The 3020 Digital Indicator can be connected to a
printer via the serial port to print out scale chits. Up
to a max. of 15 print templates can be stored. You
can obtain a service software from Soehnle Profes-
sional service centres for the 3020/3030 to design
print templates with customised contents.
The parameters listed in the standard print templates
can be used to design user-defined print templates.
In addition, organisation data (identifiers) and user-
defined parameters (such as company names) can
be included. Please contact your Soehnle Professional
service partner about your print template requirements.
Start the print routine either by pressing ENTER or
by pressing another print command, e.g. the F key.
Configuring the printer port
• Setting in Setting mode
(Setting mode > Data Processing > Interface
1 > Application > 2795.11)
• Press ENTER and the F key simultaneously to
access Setting mode.
• The arrow points to "Program Settings". Press
the TARE key to browse to "Data Processing".
Press ENTER.
• The arrow points to "Data transfer". Press the
TARE key to browse to "Interface 1". Press ENTER.
• The arrow points to "Application". Press ENTER.
• The arrow points to "2795.11". Press the TARE
key or the F key to select the printer to be con-
nected.
• Press ENTER to confirm.
Connection options (factory setting):
none
2795.11 (Soehnle Professional printer)
2795.12 (Soehnle Professional printer)
Data Processing (PC)
Barcode (barcode reader)
Large-format
display S302 (monitor)
Info about printer
Soehnle Professional printers are stored as standard.
However, you can also set up other printers using
the 3020/3030 Service Software. Other parameters
(baud rate, data bits, parity and XON/XOFF) can be
assigned as specified in the printer manual. Please
contact service personnel authorised by Soehnle
Professional. The parameters set at the factory are
configured for Soehnle Professional printers.
not active: Hold mode is off.
Still/Key: Value freezes.
Press the ON/OFF to cancel Hold mode.
Still/Empty: Value freezes.
Clip off the scale to cancel Hold mode.
Max/Key: Max. value freezes (at standstill).
Press the ON/OFF key to cancel Hold mode.
Max/Empty: Max. value freezes (at standstill).
Clip off the scale to cancel Hold mode.
Delay/Key: Max. value freezes (movement).
Press the ON/OFF key to cancel Hold mode.
Delay/Empty: Max. value freezes (movement).
Clip off the scale to cancel Hold mode.