Filter
Top Products
ENGLISH
Bed scale 7711
24
23 Print error
24 Print template memory corrupt
25 No print template(s)
26 Printer update cancelled
30 Alibi memory full
33 Alibi memory contents corrupt
34 Alibi memory empty
35 No or defective alibi memory
36 Cannot write alibi
37 Alibi memory unreadable
40 General data format error
41 Input value too small
42 Input value too big
44 Power-off not allowed
50 Value below zero range limit
> Zeroing not possible because measured value
is outside the set zero range limit
05 Zeroing not possible
> Deviation from zero point too large
06 Taring no possible
> Empty scale, scale underloaded or overloaded,
manual tare input with tare value above max. load
07 Print not permitted
08 No mass unit switchover
09 Print signal buffer full
10 Load cell signal overflow
11 No measuring point signal
12 Check sensor position
> Incorrect lever setting for at least one
weighing device or no weigh on at least one
weighing device (plausibility check active)
13 Converter failure
15 Measuring point write-protected
16 No measuring point detected
18 Measuring point not zeroed
20 Print format empty
6. Error messages
■ Error numbers > Cause / Remedy / Info