Filter
Top Products
– 16 –
4. When all the keys on the set and on the remote commander are
considered as OK, the following displays are shown for 4 sec-
onds.
(The key pressed to enter the Key Check mode has been checked
even if it is not pressed in this mode)
Example1: When the keys on the set are considered as OK:
**:AD value of the remote commander key (hexadecimal 00
to FF)
Example2: When the keys on the remote commander are con-
sidered as OK:
**:AD value of the remote commander key (hexadecimal 00
to FF)
5. When all the key have been checked, the system terminates the
Key Check mode and return to the test mode (display check
mode).
Key Check Mode
This set can check if the set and remote commander function nor-
mally.
• Setting Method of Key Check Mode
1. Setting the test mode (see page 12).
2. Press the [DISPLAY] key for several seconds (about 3 sec-
onds) activates the key check mode. (At the last two digits,
AD value of remote commander key line is displayed in hexa-
decimal)
**:AD value of the remote commander key (hexadecimal 00
to FF)
3. When each key on the set and on remote commander is pressed,
its name is displayed on the remote commander LCD. (The
operated position is displayed for 4 seconds after the slide switch
is operated. If any other key is pressed during this display, the
remote commander LCD switches to its name display.)
Example1: When >/N key on the set is pressed:
**: AD value of the remote commander key (hexadecimal 00
to FF)
Example2: When N > key on the remote commander is
pressed:
**:AD value of the remote commander key (hexadecimal 00
to FF)
000 **
Remote commander LCD display
000 FF **
Remote commander LCD display
000 rPLAY **
Remote commander LCD display
888 SET OK **
888
Remote commander LCD display
Set LCD display
All lit
888 RMC OK **
888
Remote commander LCD display
Set LCD display
All lit