Filter
Top Products
Additional Information
92
General setup
information
Setting the RF unit
When connecting this unit to the TV using only the antenna cable, you
must set the RF UNIT switch on the rear of the unit so that the TV can
receive the correct signal from the this unit.
1 Set the RF UNIT switch to CH3 or CH4, whichever channel is not
used in your area. If both are used, set the switch to either channel.
2 Press POWER to turn on this unit.
3 Press TV/VTR to turn on the VTR indicator in the unit’s display
window.
4 Press CH/PRESET +/– to display a channel number in the display
window. Select an active channel number in your area.
5 Turn on your TV and set it to the channel you selected in step 1
(channel 3 or 4).
The selected TV channel broadcast appears on the TV screen. If the
channels change when you press CH/PRESET +/– on this unit, you
have made the correct setting.
Whenever you use this unit, set the TV to the channel selected in step
1.
Attaching the external antenna connector
When using a 300-ohm twin lead cable for VHF/UHF antenna, use the
EAC-32 antenna connector (not supplied) to connect the antenna to the
VCR.
1 Loosen the screws on the antenna connector.
2 Wind the twin leads around the screws on the antenna connector.
3 Retighten the screws.
EAC-32 Antenna
connector (not
supplied)
300-ohm twin
lead cable
TV
TV/VTR CH/PRESET TUNING +/–
RF UNIT
CH3
CH4