Filter
Top Products
33Installation of the Operation Software
Set TCP/IP Config.
The IP Address, Netmask, Gateway, and DNS have been
set at the factory, but you can change them as required.
1
Press the jog roller to select an item to be changed.
2
Press the jog L or R button to select the digit to be
changed.
3
Turn the jog roller to set the value.
4
Press the select R button when you are finished
settings.
The set values are stored.
To cancel the set values, press the select L button.
To retrieve the default settings, select Default.
Calibrate Touch Panel
Touch the center of the crosshairs displayed on the touch
panel with a pen or fingertip. The relationship between the
screen and touched position is calibrated.
To calibrate from the beginning again, touch the center of
the screen. Then the previous operation is canceled, and
you can start the calibration from the beginning.
Scribble Test
You can check the operation status of the touch panel by
scribbling. Scribble on the screen with a pen, and the trace
will be shown.
Self Diagnosis
The operation of the jog roller, jog buttons, function
buttons, and control knobs can be checked.
Installation of the
Operation Software
The UCP-8060 is shipped with the operation software for
several products installed. If you wish to use another
product, install the operation software for the product
following the procedures below. It is also necessary to
install operation software when you update the system
files.
You can install the operation software using a Memory
Stick or via the Internet (HTTP server).
To obtain the operation software, consult your Sony
representative.
Note
The memory capacity to store the operation software is
limited. You may remove some operation software when
you intend to install a new software.
For details on removing software, see “Removing the
Operation Software” on page 36.
Requirements
• Computer (to enable copying files to a Memory Stick if
a Memory Stick is to be used)
• Operation software to be installed (two files, with the
extension, “jar” and “jad”)
Installation using a Memory Stick
• Memory Stick
Preparations
1
Copy the operation software to a Memory Stick or to
an HTTP server using a computer.
To copy onto a Memory Stick, prepare a folder named
MSSONY/PRO/UCP, and copy to a folder under
UCP.
2
Turn the UCP-8060 On.
The Main Screen appears.
For details on the IP address of the HTTP server and the
network connection, consult your network administrator.