Filter
Top Products
35Installation of the Operation Software
5
Press the select R button (Save).
The Menu display appears.
The following procedures depend on whether operation
software has been installed or not.
If operation software has been installed.
1
Select Install by turning the jog roller.
2
Press the select R button (Enter).
The Install display appears.
3
Touch the keyboard icon on the task bar.
The keyboard appears on the screen.
4
Enter the URL address that contains the operation
software to be installed and the filename of the
operation software, then press the select R button
(OK).
Note
Be sure to enter the filename of the operation software
with the extension “jad.”
5
Press the select R button (Go).
Information on the operation software to be installed
appears.
6
If the displayed information is correct, press the select
R button (Yes).
Installation begins. While reading and writing data,
the status indicator is lit or blinking.
When installation is completed, a message to indicate
this appears on the screen.
Note
While reading and writing data, never turn the power
of the UCP-8060 Off, or remove the installed
Memory Stick. The file may be damaged.
7
Press the select R button (Restart).
The Main Screen appears. Check that the name of the
installed operation software appears.
If operation software has not been installed.
1
Press the select L button (Back).
The Main Screen appears.
2
Press the select R button (Install).
The Install display appears.
3
Touch the keyboard icon on the task bar.
The keyboard appears on the screen.
4
Enter the URL address for the operation software to
be installed, and the file name of the operation
software, then press the select R button (OK).
Note
Be sure to enter the filename of the operation software
with the extension “jad.”
5
Press the select R button (Go).
Information on the operation software to be installed
appears.
6
If the displayed information is correct, press the select
R button (Yes).
Installation begins. While reading and writing data,
the status indicator is lit or blinking.
When installation is complete, a message to indicate
this appears on the screen.
Note
While reading and writing data, never turn the power
of the UCP-8060 Off, or remove the installed
Memory Stick. The file may be damaged.
7
Press the select R button (Restart).
The Main Screen appears. Check that the name of the
installed operation software appears.
Setting the URL address
1
Select “http://” with the jog roller, and push the jog
roller.
2
Touch the keyboard icon on the task bar.
The keyboard display appears on the screen.
3
Enter the URL address for the operation software to
be installed.
4
Press the select L button (OK).
The Install Settings display appears.