Filter
Top Products
34 Installation of the Operation Software
Installation
Installing using a Memory Stick
1
Insert the Memory Stick in which the operation
software has been copied into the Memory Stick slot.
2
Press the select L button (Menu).
The Menu display appears.
3
Select Install Settings by turning the jog roller, and
press the select R button (Enter).
The Install Settings display appears.
4
Select Memory Stick by turning the jog roller, and
press the select R button (Save).
The Menu display appears.
The following procedures depend on whether operation
software has been installed or not.
If operation software has been installed.
1
Select Install with the jog roller.
2
Press the select R button (Enter).
The Install display appears. Check that a file with the
extension “jad” in the Memory Stick is displayed.
3
Select the operation software to be installed by
turning the jog roller, and press the select R button
(Go).
Information on the operation software appears.
4
If the displayed information is correct, press the select
R button (Yes).
Installation begins. While reading and writing data,
the status indicator is lit or blinking.
When installation is complete, a message to indicate
this appears on the screen.
Note
While reading and writing data, never turn the power
of the UCP-8060 Off, or remove the installed
Memory Stick. The file may be damaged.
5
Remove the Memory Stick.
6
Press the select R button (Restart).
The Main Screen appears. Check that the name of the
installed operation software appears.
If operation software has not been installed.
1
Press the select L button (Back).
The Main Screen appears.
2
Press the select R button (Install).
The Install display appears. Check that the file with an
extension “jad” in the Memory Stick is displayed.
3
Select the operation software to be installed by
turning the jog roller, and press the select R button
(Go).
Information on the operation software appears.
4
If the displayed information is correct, press the select
R button (Yes).
Installation begins. While reading and writing data,
the status indicator is lit or blinking.
When installation is complete, a message to indicate
this appears on the screen.
Note
While reading and writing data, never turn the power
of the UCP-8060 Off, or remove the installed
Memory Stick. The file may be damaged.
5
Remove the Memory Stick.
6
Press the select R button (Restart).
The Main Screen appears. Check that the name of the
installed operation software appears.
Installing using the Internet
1
Check that the UCP-8060 is connected to the Internet.
2
Press the select L button (Menu).
The Menu display appears.
3
Select Install Settings by turning the jog roller, and
press the select R button (Enter).
The Install Settings display appears.
4
Select Internet by turning the jog roller.
It is recommended to set the URL address here. Then
you can skip entering the URL address each time you
install operation software afterwards.
For details on setting the URL address, see“Setting
the URL address” on page 35.