Filter
Top Products
5-36
5. Connect one end of an RS-232 modem cable to the switch
and the other end to a modem. Plug the modem into the
phone jack. Also, be sure the modem is set to Auto-answer.
6. Configure the remote workstation to use the SLIP protocol.
7. Attach the remote workstation to a modem using an RS-232
modem cable. Plug the modem into the phone jack.
8. From the remote workstation, dial the phone number of the
modem connected to the switch. Verify that you are able to
auto-connect. Also, verify that you can ping the SLIP IP
Address.
CONFIGURING AND MONITORING