Instruction Manual
20
When disabled, the LAN port will use the values assigned to it on the
IP Addresses and Routing table below.
IP Addresses and Routing: This table allows you to assign IP
information for the LAN and WAN ports separately. If you are using
DHCP, the values for the LAN port will be lled in automatically and any
changes made will not aect the setup.
Domain Name Server: This section allows you to specify DNS servers and the default
DNS domain sux in use on the network. If DHCP
is enabled, some of these values may be supplied automatically.
Clicking the Commit button applies any changes made on this page, but leaves the
old settings active until the next time the unit restarts. Clicking Make changes eective
now applies the changes and restarts CABCONS1716I so the new settings take
eect immediately.
Ethernet Address (MAC Address): This is the Ethernet hardware address of this unit’s
LAN/WAN port. It is set at the factory and cannot be changed. You may need this
number to congure your DHCP server.
User Accounts: This menu will allow you to add accounts other than
admin to the system. These accounts will not have the authority to
change settings, but can access the Web interface and log into the
VNC console.
Selecting Delete permanently removes the user from the system. If you
enter values for a user that does not already exist under Edit User
Details, the system will create that user for you when you click Record
changes. If the user already exists, you will change the password for
that user.