Filter
Top Products
Instruction Manual
40
Manual Scan:
Manual Scan enables you to manually switch back and forth between powered
computers: left Ctrl + left Ctrl + F2. Press the up or down arrow to select the previous
or next computer in sequence. Press any other key to abort the Manual Scan.
NOTE: The Scan Type setting will determine whether computers must be eye-marked
to be included in the scan.
Scan Rate:
Scan Rate sets the duration between switching to the next computer in Auto Scan
mode: left <Ctrl> + left <Ctrl> + F3
The unit switches between scan intervals of 3, 8, 15 and 30 seconds.
Keyboard Typematic Rate:
You can adjust the keyboard typematic rate (given in characters/sec). This setting
overrides the keyboard typematic rate of your BIOS and any operating system. To
activate, key in left <Ctrl> + left <Ctrl> + F4, following which the unit will switch
between rates of 10, 15, 20 and 30 characters/sec.
Audio Stick:
A multimedia module can be LINKed to the back of the master KVM for selecting
microphone and stereo speaker signals. There are two options for Audio Stick: On
and O. When set to On, audio selection follows computer selection. When set to O,
audio selection stops following computer selection. It is useful if you want to listen to a
particular computer’s audio signal while operating other computers. To activate, key in
left Ctrl + left Ctrl + F5.
NOTE: This is an optional feature requiring that a separate device be connected to the
master switch.
Changing Your Conguration
After the initial power up, any device (either a KVM or a PC) can be added or removed
from any PC x port on the KVM without having to power down the Master KVM Switch.
Make sure that devices are turned o before connecting them to the Master KVM
switch. Please note that after changing your conguration, the OSD will automatically
update to reect the new conguration.