Filter
Top Products
Instruction Manual
42
When the front panel LEDs flash, disconnect the power adapter from 5.
the SV1107IPEXT.
Remove the jumper cap from J9.6.
Close the housing and reconnect the SV1107IPEXT power adapter 7.
and cables.
After starting back up, you can use the default Username and Pass 8.
word to log in.
Please Note: Performing this procedure also returns all settings to their
defaults. It will not remove Users or their passwords.
Connecting From the Internet
To simplify setup, disable your network firewall. Once you have connected
to the unit from the Internet, restore your firewall.
You will need to configure the firewall to pass through the ports selected
for the Windows and Java clients (9000 and 9002 are the default ports).
Because each router manufacturer / ISP / and Dynamic DNS service is
slightly different, the following steps are general in nature and serve only
as guidelines. If you have specific questions, please contact the manufac-
turer of your router, ISP, or the FAQ s page of the Dynamic DNS service
you use for assistance.
The following three items are needed to connect to the SV1107IPEXT
from the Internet:
A method to find the current IP address of the SV1107IPEXT (on your •
network) if no static IP Address is assigned. Some routers can use the
name of the network device to locate it on your network. The network
name of the SV1107IPEXT can be found under Device Name
in the information box located on the SV1107IPEXT main screen
A method to find your current external IP address. ISPs assign •
temporary external IP address so; unless you purchased a static IP
address from your ISP, you have a dynamic IP address that changes
periodically)
A method by which your router knows where to direct the incoming •
Client software. This is port forwarding, set up to direct the incoming
Client to the SV1107IPEXT