Filter
Top Products
SVx41HDI Series Server Remote Control: Instruction Guide
7
Network Configuration (IP address. netmask, gateway)
Dynamic Host
Configuration Protocol
(DHCP)
Automatic network
configuration using DHCP
is: Enabled/Disabled.
This feature applies to the
LAN port on the rear panel,
and is enabled by default.
When enabled, the unit will
automatically configure
itself with an IP address
when a DHCP server is present. When disabled, the LAN port will use the values
assigned to it on the IP Addresses and Routing table below.
IP Addresses and Routing
This table allows you to assign IP information for the LAN port. If you are using DHCP,
the values for the LAN port will be filled in automatically and any changes made will not
affect the setup.
Domain Name Server (optional)
This section allows you to specify DNS servers and the default DNS domain suffix in use
on the network. If DHCP is enabled, some of these values may be supplied
automatically.
Commit Network Changes
Clicking the Commit button applies any changes made on the page to the configuration,
but leaves the old settings
active until the next time
the unit restarts. Clicking
Make changes effective
now applies the changes
and restarts the unit so the
new settings take effect
immediately.
User accounts: add, delete and
change passwords
This menu will allow you to add
accounts other than admin to the
system. These accounts will not
have the authority to change settings, but can access the Web interface and log in the VNC